Inlet and Exhaust Manifold Stud Torque

The place to discuss all matters relating to David Brown Tractors. You will need to register your user name before you can post. If you have already registered could you please make sure that your location details have been completed. Go to My Account in the Main Menu on the left, and then go into "Edit Your Information" and complete your location details. Give the Country (and State/Province if you wish) if outside the U.K. County if within the U.K. Location details helps other members if you need spares, technical advice, or the nearest practical help.


David Brown Tractor Club Ltd
Forum/website Disclaimer

1. This [forum/website/chat room] and the advice and opinions expressed herein is not a solution for mechanical, electrical, valuations, other problems, breakdowns or issues experienced in relation to the vehicles referenced.

2. If reliance is thought to be placed on any of the information guidance or input provided such information will be expressly confirmed as appropriate to be relied upon.

3. In the absence of any such confirmation no reliance should be suggested or inferred.

4. Members must not disclose information to 3rd parties in anticipation that reliance will be given by non-members.

5. Non-members must not purport to give advice on behalf of David Brown Tractor Club.

6. If you or someone you know is experiencing difficulties or repeated breakdowns you must seek assistance for an appropriately qualified expert who holds themselves out as such.

7. Any comments are free of charge and made or posted on an ex gratia basis. No member or non-member may advertise their professional services

Any user inactive for more than 3 months will automatically be deactivated, please contact if you would like to be reactivated.

Please be aware that your user name and entered location can be seen by all members. We only store information you have entered which is your email address and username, your IP is also stored, we have no access to private passwords.

If you do not agree with your information being stored, please do not register an account, If you wish to unsubscribe at any time please email giving your username.

Amended 27/10/18

Moderators: Segrie61, admin

Post Reply
Posts: 35
Joined: Tue Feb 07, 2006 8:31 am

Inlet and Exhaust Manifold Stud Torque

Post by Andrew.M » Wed May 13, 2020 9:28 pm


When removing the exhaust manifold and inlet manifold from my Case 1394 a few of the studs came out from the head along with the nuts. What torque should the studs be tightened to when refitting. They are 3/8 unc.
I am aware the nuts need to be tightened to 25lb/ft but it's the actual studs which go into the head I could do with knowing the torque for

User avatar
Posts: 2217
Joined: Fri Feb 24, 2012 10:01 pm
Location: Monmouthshire

Re: Inlet and Exhaust Manifold Stud Torque

Post by db2d » Thu May 14, 2020 7:57 am

25 ft lb

User avatar
Posts: 830
Joined: Tue Oct 11, 2011 6:18 am
Location: beautiful Coopernook NSW. near Taree. NSW. Australia

Re: Inlet and Exhaust Manifold Stud Torque

Post by cobbadog » Thu May 14, 2020 12:30 pm

Plus use locktite or similar

Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests