Page 1 of 1

950 quadrant pictures

Posted: Wed Mar 07, 2018 7:00 pm
by joeproctor
i have almost finished restoring a 950 early model (dash like a cropmaster) it came to me with the mudguards missing,i need a picture of the quadrant position so that i can get it fitted and working.
can you help?

Re: 950 quadrant pictures

Posted: Fri Mar 16, 2018 8:29 pm
by joeproctor
i have over 80 hits on this subject has no one got a 950 they can take a photo of the quadrant lever assembly in situ?

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 3:23 am
by cobbadog
Sorry mate I have no pics of what you need.

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 10:28 am
by Scooby
I suddenly remembered that I have some brochure scans Joe and I had a look. I found 2 that show the 950 hydraulic controls but they are different so I have attached them both but neither are very clear. I also have 950 spares books but they don't show how they are mounted. Let me know which one is applicable and I'll crop the photo. and enlarge the relevant bit to make it a bit clearer.

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 3:26 pm
by joeproctor
scooby, could you send these to my email address
regards
joe

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 4:41 pm
by Scooby
Yes Joe, I'll send these and the link box ones. DL.

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 9:59 pm
by joeproctor
thank you for the email, just the job!
regards
joe

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 10:04 pm
by Scooby
You're welcome Joe. It's what we do at planet DB. :D

Re: 950 quadrant pictures

Posted: Sun Mar 18, 2018 11:43 pm
by db2d
I have asked a friend to take some pictures of the quadrant on his tractor. It will be a few days before I get them.

Re: 950 quadrant pictures

Posted: Tue Mar 20, 2018 6:31 am
by joeproctor
thank you mr db2d much appreciated, hope you received my letter!
regards
joe

Re: 950 quadrant pictures

Posted: Tue Mar 20, 2018 11:40 am
by SteveCollett
Those pictures look to me like the later 950 control the earlier one was quite different, sorry I have no pictures

Re: 950 quadrant pictures

Posted: Tue Mar 20, 2018 1:18 pm
by ollek
Please consider that there was an 950 with a hydraulic system almost as the one in a 25D. That is with the hydraulic control lever fitted to the right hand side mud guard. These tractors had a hydraulic system with lift, hold, lower and TCU. And then there was a 950 Implematic with a completely different hydraulic system. That is with the hydraulic lever fitted to a housing in front of the rear axle. The top picture supplied by Scooby is from a 950 Implematic. The hydraulic system in Implematic tractors had lift, hold, lower, TCU end draught control via a spring loaded top link. Later Implematic tractors also has height control by moving the cable from the top link to the end of the cross haft.

Re: 950 quadrant pictures

Posted: Tue Mar 20, 2018 6:50 pm
by joeproctor
steve the bottom picture that scooby has posted is the early type i need a side on picture to show where the lever quadrant mounts and showing the tie rods position on the actuators on the axle